Important; Installation Procedures - Toto EcoPower STD TELS10 Serie Manual De Instrucciones Y Del Propietario

NOTE: Before installing the product, be sure to thoroughly flush the supply pipes of dirt
and debris. Shut off the water supply at the stop valves after flushing.
1. See the rough-in dimension page to determine the proper location for the controller.
2. Remove the screws on the front of the controller cover and pull to remove.
3. Mount the bracket on the wall. If necessary, use wall anchors (see ill. 1).
4. From the top, place controller into the hole in the bracket. From below the bracket,
fasten the large nut to secure the controller (see ill. 2).

IMPORTANT!

Be sure to install controller in the correct orientation as shown. Otherwise,
product will not function properly.
5. Connect the water supply line to the inlet adapter (see ill. 3).
NOTE: If using a thermostatic valve (sold separately), please refer to its installation
manual for details.
ill.1
To Install Deck-Mounted Models (ill. 4):
Secure the spout to the countertop with the included
bracket and hexagonal nut. Make sure that the spout
is mounted with the tip directed towards the center
of the basin.
To Install Helix Wall-Mounted Models (Ill. 5 & 6):
NOTE: The addition of a 2 x 4" framing behind the
spout installation location is highly recommended.
1. Place mounting template on wall at desired location
and mark all holes. Drill a 5/8" (16mm) diameter hole at
the spout mounting location (center) for the supply tube
and sensor cord to pass through.
INSTALLATION PROCEDURE
Install the Controller
ill. 2
Mount Bracket
Nut
Install the Spout
ill. 3
Mount Bracket
Nut
ill. 4
Gasket
4
Supply Hose
Angle Stop
SPOUT
Mounting Bracket
Sensor cord
Nut
Spout connecting
hose