Complete The Installation - Kohler K-4830 Guia De Instalacion

2. Install the Bidet
Install the bidet faucet and drain according to the manufacturer's
instructions.
Set the bidet on the floor in its mounting location.
Trace the outline of the bidet base, and mark the location of the two side
mounting holes.
Remove the bidet from the mounting location.
Drill two 3/16" holes at the marked side mounting hole locations.
Thread the floor bolts (included) into the mounting holes.
Apply a bead of sealant around the base of the bidet, and carefully align the
bidet inside the outline drawn on the floor.
Position the bidet in the mounting location so both of the floor bolts extend
through the bidet side mounting holes.
CAUTION: Risk of personal injury or product damage. Vitreous china
can break or chip easily if the nuts are overtightened or the product is
handled carelessly.
Assemble the bolt cap bases, washers, and nuts. Hand-tighten the nuts, then
tighten an additional 1/2-turn with a wrench.
If the floor bolts extend more than 1/4" (6mm) from over the top of the nut,
loosen the nut and thread the bolt further into the floor. Retighten the nuts,
and install the bolt caps.

Complete the Installation

Connect the water supplies and drain.
Kohler Co. 3 1010409–2–B