Nebulizer Set-Up - Pari LC Plus Instrucciones De Uso

C. NEBULIZER SET-UP
1. Clean/Disinfect Nebulizer Cup:
D-E to clean and/or disinfect your nebulizer
prior to first use. Re-assemble nebulizer.
2. Connect Tubing To Compressor:
of Wing Tip tubing to the air outlet on the
®
compressor. It should fit snugly (Fig. A).
3. Load Medication: Remove the nebulizer insert
by twisting counter-clockwise until it stops
and lift up (Fig.B). Pour the prescribed dose
of medication into the nebulizer cup (Fig.C).
Never fill past the max. fill line of 8ml for the
LC PLUS and 6ml for LC
®
the nebulizer insert making sure the two
alignment rings are lined up with each other.
4. Attach Mouthpiece or Mask:
mouthpiece, attach the mouthpiece to the
nebulizer outlet with the expiratory valve
facing up. Then attach the inspiratory valve
cap by pressing it firmly into the top of the
nebulizer. If using a mask, refer to the mask
instructions.
5. Attach Tubing To Nebulizer Cup:
other end of the Wing Tip
of PARI reusable nebulizer (Fig. D).
A
4 Questions? 1.800.FAST.NEB (327.8632) | PARI.com
Refer to Section
Insert one end
STAR. Replace
®
If using the
Firmly press
tubing to bottom
®
6. Starting Treatment: Sit in a relaxed, upright
position and turn the compressor "ON".
7. Nebulizer Position: Place the mouthpiece
on top of tongue and close lips around it.
Take slow, deep breaths. As you inhale, the
inhalation valve opens.
8. Breathing: For mouthpiece, inhale and exhale
slowly through your mouth. As you exhale,
the valve on the mouthpiece opens to allow
the exhaled mist to escape. For mask, place
mask over nose and mouth and inhale and
exhale slowly.
9. Complete Treatment:
medication is gone or you hear a slight
"sputtering" sound. Turn compressor off.
WING TIP TUBING
®
It is normal if moisture or condensation
appears in your tubing during a treatment. This
can be a natural effect of your environment's
temperature. If this happens, finish your
treatment and then disconnect the tubing from
the nebulizer. Leave the other end attached to
the compressor air outlet and let run for a few
minutes. The warm air from the compressor
will dry the inside of the tubing. Use a damp
cloth to wipe the exterior of the tubing.
B
Continue until the