Xylem SI Analytics CT 72/2 Manual De Instrucciones página 99

in commands: Asking for parameters or temperature values to be displayed.
Command
version
status
in_pv_00
in_pv_01
in_pv_03
in_pv_04
in_sp_01
in_sp_02
in_sp_03
in_par_01
in_par_02
in_par_03
in_par_05
in_par_06
in_par_07
in_par_08
in_mode_01
in_mode_05
in_mode_08
Parameter Response of circulator
none Number of software version (V X.xx)
none Status message, error message (see page 100)
none Actual bath temperature.
none Heating power being used (%).
none Temperature value registered by the safety sensor.
none Setpoint temperature of the excess temperature protection
none Working temperature „SETPNT 1"
none High temperature warning limit „OverTemp"
none Low temperature warning limit „SubTemp"
none Te - Time constant of the external bath.
none Si - Internal slope
none Ti - Time constant of the internal bath.
none Factor pk/ph0:
Ratio of max. cooling capacity versus max. heating capacity
none Xp control parameter of the internal controller.
none Tn control parameter of the internal controller.
none Tv control parameter of the internal controller.
none Selected setpoint:
0 = SETPNT 1
1 = SETPNT 2
2 = SETPNT 3
none Circulator in Stop/Start condition:
0 = Stop
1 = Start
none Adjusted control dynamics
0 = aperiodic
1 = standard
Remote control
99