Eschenbach MaxDetail Clip Manual De Instrucciones página 9

When you wish to stop using the "MaxDetail Clip",
simply flip the clip up, it is not necessary to remove
it.
To allow an optimal line of sight on both large and
small eyeglasses, the lens assembly on the clip
can be moved vertically. To do this, it is necessary
to unscrew the lens assembly with a small Philips
screwdriver and rescrew it onto the clip arm at one
of 5 possible positions.
The clip should generally lie in the lower line of
sight through the eyeglasses so that you can still
orient yourself in the room by looking through the
upper part of the eyeglasses and over the clip.
If you cannot achieve good results with the "Max-
Detail Clip", this may be a result of one of the fol-
lowing situations:
• You may have selected a working distance
that is too far or two short.
• You may be experiencing a vertical offset
because you have attached the "MaxDetail
Clip" at too steep an angle.
• Your pupil distance may lie outside of the
pupil distance range of the "MaxDetail Clip".
- 9 -