Air Compressor; Procedure - Wagan Tech 900 Amp Battery Jumper Manual De Usuario

Ocultar thumbs Ver también para 900 Amp Battery Jumper:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

AIR COMPRESSOR

This Battery Jumper is equipped with an air compressor that can provide up to 260 PSI (pounds
per square inch) of pressure for a variety of uses such as vehicle tires and sports equipment.
CAUTION: Be careful not to over inflate, monitor the compressor gauge while inflating. Never
connect or disconnect the nozzle with the compressor operating. To avoid overheating, do
not operate the air compressor for more than 10 minutes at a time. After 10 minutes, allow the
compressor to cool for 15 minutes before using again.

Procedure

In the event that the vehicle tire is completely flat, raise the vehicle using a recommended jack
before inflating the tire.
1. Before any tire inflation, look for manufacturer's recommended inflation pressure.
2. Unwind and extend the air hose from the bottom, back side of the unit.
3. Position the Battery Jumper so that you can see the pressure gauge.
4. Make sure the chuck lever is positioned up (away from the chuck opening).
5. Determine if you will need an air hose adapter for your object.
• To inflate a vehicle tire:
a. Remove the valve cap from the valve stem of the tire.
b. Attach the chuck of the air hose to the tire's valve stem.
c. Push the chuck lever down to secure the chuck to the valve stem.
• To inflate a sports equipment, air mattress, rafts, or other plastic inflatables:
a. Insert the proper valve stem adapter into stem connector as far as possible.
b. Push the chuck lever down to secure the adapter.
c. Remove the valve cap from your inflatable object if there is one.
d. Insert the other end of the valve stem adapter into inflatable's air valve opening
as far as possible.
6. Set the Air Compressor Switch on to the "I" position to start inflation.
7. Monitor the pressure gauge while inflating the tire.
8. When recommended tire pressure has been reached, turn off the air compressor.
9. Disconnect the hose and replace valve cap.
10. Return the hose back to its compartment for storage.
11. Recharge the Battery Jumper as soon as it is convenient.
Wagan Tech and wagan.com are trademarks used by Wagan Corporation.
User's Manual—Read before using this equipment
©2017 Wagan Corporation. All Rights Reserved.
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

2412

Tabla de contenido