Install The Air Conditioner - Haier QHC08 Instrucciones De Instalación Y Manual Del Usuario

INSTALLATION INSTRUCTIONS

4. INSTALL THE AIR CONDITIONER

IN THE WINDOW
A. Mark the center of the window. Set the air
conditioner in the window so that is it centered.
Place the air conditioner so that front edge of the
bottom mounting rail is against the back edge of the
sill.
B. Bring the window down so that the front edge of the
top mounting is in front of the window. Make sure
that the air conditioner is level or tilting slightly to
the outside.
C. Extend the curtain panels until they fill the window.
Mark the location of the holes in each corner. Use
the drill and 1/8" drill bit to drill pilot holes. Use 4
type B screws to secure the side panels in place.
Type B screws
49-7826-1
A. Loosen the screw on the right hand side of the air
conditioner near the bottom.
B. Slide a side bracket over the screw so that the
bracket is resting on the window sill. Tighten the
screw.
C. Use a 1/8" drill bit to drill a starter hole into the
window sill through the holes in the side bracket.
Use 4 type B screws to attach the side bracket to the
window sill.
D. Repeat the side bracket installation on the left side.
E. Measure and cut adhesive foam backed sheet. Apply
over side curtain and frame.
Side curtain foam
Weather seals
11