Troy-Bilt TB25ET Manual Del Operador página 10

OPERATING THE EZ-LINK™ SYSTEM
The EZ-Link™ system enables the use of these optional
Add-Ons.
Blower/Vacuum . . . . . . . . . . . . . . . . . . . . . . . . . . . TBBV
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBGC
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBLE
Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . TBHS
Snow Thrower . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBST
Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . . . TBSS
Tree Pruner . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBTP
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBTB
WARNING: Read and understand the
operator's manual for each add-on prior to
operation.
Removing the Cutting Attachment or Add-Ons
1. Turn the knob counterclockwise to loosen (Fig. 9).
2. Press and hold the release button (Fig. 9).
3. While firmly holding the upper shaft housing, pull
the cutting attachment or add-on straight out of the
EZ-Link™ coupler (Fig. 10).
WARNING: To avoid serious personal injury
and damage to the unit, shut unit off before
removing or installing add-ons.
Installing the Cutting Attachment or Add-Ons
NOTE: To make installing or removing the add-on
easier, place the unit on the ground or on a work
bench.
1. Turn knob counterclockwise to loosen (Fig. 9).
EZ-Link™ Coupler
Knob
10
OPERATING INSTRUCTIONS
Release Button
Guide Recess
Fig. 9
2. While firmly holding the add-on, push it straight into
the EZ-Link™ coupler (Fig. 10).
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 9).
EZ-Link™ Coupler
Upper Shaft Housing
3. Turn the knob clockwise to tighten (Fig. 11).
CAUTION: Lock the release button in the
primary hole and securely tighten the knob
before operating this unit.
90˚ Edge
Trimming Hole
CAUTION: The cutting attachment and
EZ-Link™ add-ons are to be used in the
primary hole unless stated otherwise in the
specific add-on operator's manual. Using the
wrong hole could lead to personal injury, or
damage to the unit.
For decorative trimming/edging with the line head cutting
attachment, lock the release button of the cutting
attachment into the 90° hole or the 180° hole (Fig. 11).
For edging with the edger add-on, lock the release
button of the cutting attachment only into the 180°
trimming hole/ primary hole (Fig. 11).
Release Button
Primary Hole
Lower Shaft Housing
Fig. 10
180˚ Trimming Hole/
Primary Hole
Knob
Fig. 11