Descargar Imprimir esta página

Ega Master 79602 Manual De Instrucciones página 27

Taladro neumático

Publicidad

Idiomas disponibles

Idiomas disponibles

For gearless impact wrenches and small grinders, only SAE 5 W
For damp compressed air, oils are to be used that take up water (without losing the lubricating
effect) and that contain anticorrosive additives. At lower temperatures (especially for work outside) it
may be necessary to use an antifreeze lubricant (e.g., kilfrost, BP Energol AX 10, Kompranol N 74).
For saw-chain lubrication on chain saws: Machine oil with adhesive additive, viscosity c ST 49-
55' (6.5 – 7.5E) / 50ºC
Greases (free of resins and
acids)
Designation in accordance
with DIN 51502
Consistency class (DIN 51818)
Saponification type
Dripping point
Worked penetration
Temperature range
Multi-purpose greases for
antifriction and friction
bearings and gears
KL 2 K
2
lithium
185ºC
265 to 295
-25ºC to 125 ºC
OILER TYPES USED ON OR WITH OUR TOOLS
Oiler to mount on the machine or connect in the hose line
Setting the oiler: The adjustment screw is visible after
removing the screw plug. The oil supply is decreased by
tightening the screw, and by loosening the screw, more
oil gets into the machine. In most cases it is sufficient to
tighten or loosen the screw by ¼ or ½ of a turn. When
plugged, clean borehole (diam. 2mm) with wire.
Correct setting: When under pressure and with the filler
screw open, the oil must bubble slightly. The filling lasts
For stationary pneumatic machines and motors, the
lubrication is carried out by lined-up oilers for
Setting of oilers: Shut off air supply. Open plug. Loosen
visible lock nut with a socket wrench. Using a
screwdriver turn back the tightened screw plug by ¼ to
½ of a turn and then lock again. No oils are to get into
the borehole "a" when filling. Close plug and open the
Correct setting: A piece of paper held for a short time in
front of the outlet must be coated with oil without drops
Special greases for high-speed
-25ºC to 100ºC
for approx. 8 operating hours.
Line oiler
horizontal or vertical installation.
air supply.
forming.
miter gears
G 00h
00
sodium
145ºC
400 to 410
27

Publicidad

loading

Este manual también es adecuado para:

7960379604