Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
materials. (Petroleum based products, thinners or
any other solid object that carries a flammable
warning label.)
• Close the valve of the gas cylinder or the regula-
tor after use.
• The use of this appliance in enclosed areas can be
dangerous and is PROHIBITED.
USAGE METHODS
Follow these instructions carefully to avoid seriously damaging your barbecue and causing
injury to yourself and to property.
1.
Assemble the barbecue following the assembly instructions carefully.
2.
Connect the gas hose to the barbecue. Connect the regulator to the hose.
3.
Connect the regulator to the cylinder valve following the regulator instructions supplied
with the regulator.
4.
Turn all of the control knobs to the 'OFF' position before turning on the gas supply to the
appliance.
5.
Operate the regulator in accordance with the instructions supplied with the regulator.
LIGHTING INSTRUCTIONS
1.
Connect the gas cylinder to the barbecue following the instructions supplied with the
regulator.
2.
Turn all the control knobs to the 'OFF' position.
3.
Turn 'ON' the gas supply at the cylinder or regulator switch following the regulator con-
nection and operating instructions. Check with the use of soapy water for any gas lea-
kage between the bottle and the regulator and the gas valve. Any leakage will show as
bubbles in the area of the leak. If leak is found do not use the barbecue. Consult your gas
or barbecue supplier for advice.
4.
To light the left hand burner, push down the left hand control knob and keep pressing
whilst turning anti-clockwise to the "Full rate" position whilst press the ignition button
sited between the two knobs up to four times in rapid succession. This will light the left
hand burner.If not please repeat this process.
5.
If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes
before retrying the ignition sequence.
6.
If the burner does not stay alight, please repeat step 4.
7.
When the burner is lit. Adjust the heat by turning the knob to the High/Low position.
8.
To light the right hand burner, push down the right hand control knob and keep pressing
whilst turning anti-clockwise to the "Full rate" position whilst press the ignition button
sited between the two konbs up to four times in rapid succession. This will light the right
hand burner. If not please repeat this process.
9.
If the burner has not lit after two attempts, turn 'OFF' the gas tap and wait 5 minutes
4
22
Publicidad
Tabla de contenido
