Adjusting Head Support; Securing The Child - Diono everett NXT Manual De Instrucciones

ADJUSTING THE HEAD SUPPORT
The head support height can be adjusted for best fit to
your child and to ensure proper placement of the
Vehicle Shoulder Belt.
1. Turn the head support locks outwards to unlock the
head support.
2. Grip the handle adjustment and pull it out and
upwards to adjust the head support.
3. When it reaches the desired height, release the
handle and turn the head support locks inward to
lock it fully into position.
WARNING! Adjust the head support height before
fitting the child in the vehicle seat.
16
1-855-463-4666
1. Place booster seat on vehicle seat so it is resting
firmly on vehicle seat bottom and touching the vehicle
seat back. A gap is acceptable as long as the head
support is touching the vehicle seat back or head rest.
1
2. Properly position child: sitting upright and seated
all the way back in the booster seat.
3. Adjust head support to proper height: The
shoulder belt guide should be slightly above the
child's shoulders (at least 1 cm).
2
4. Feed the vehicle's diagonal shoulder belt portion
of the seat belt through the
into the side of the seat opposite the seat belt buckle.
3
5. Fasten vehicle seat belt across child. The lap
portion of the seat belt should rest within both lower
belt guides. The diagonal shoulder belt portion should
route inside the lower belt guide closest to the buckle
and over child's shoulder.

SECURING THE CHILD

1cm
RED
RED shoulder belt guide
www.diono.com
1cm
17