Lower Anchor Removal & Head Support; Securing The Child - Diono cambria 2 Manual De Instrucciones

LOWER ANCHOR REMOVAL & HEAD SUPPORT
DISENGAGING LOWER ANCHOR INSTALLATION
Follow the previous instructions in reverse order.
1. Reach under the bottom of the booster seat and depress the cam
lock lever while pulling the seat away from the vehicle seat back until
the lower anchor straps are extended all the way.
2. Disconnect LATCH connectors from vehicle anchors.
3. Pull lower anchor adjuster straps to recess the LATCH connectors
into the back of the booster seat bottom for safe storage.
ADJUSTING THE HEAD SUPPORT
The head support height can be adjusted for best fit
to your child and to ensure proper placement of the
Vehicle Shoulder Belt. Squeeze the head support
adjustment lever on the back of the booster
seat while adjusting its height up or down to fit the
child.
18
1-855-463-4666
WARNING! Use ONLY the lap and shoulder belt system when
restraining the child in this booster seat.
1. Place booster seat on vehicle seat so it is resting
firmly on vehicle seat bottom and touching the
vehicle seat back. A gap is acceptable as long as
the head support is touching the vehicle seat back
or head rest.
2. Properly position child: sitting upright and seated
all the way back in the booster seat.
3. Adjust head support to proper height: The
shoulder belt guide should be slightly above the
child's shoulders (at least 1 cm). Squeeze the head
support adjustment lever on the back of the
booster seat while adjusting it's height up or
down to fit the child.
4. Feed the vehicle diagonal shoulder belt portion
of the seat belt through the
guide into the side of the seat opposite the seat
belt buckle.

SECURING THE CHILD

DO NOT use lap belt only.
RED
RED shoulder belt
diono.com
19