OPERATING INSTRUCTIONS
WATER DRAINAGE
3. Continuous Drain - Heat Mode
During heat mode, you may wish to set up the continuous drain option so that the appliance will
automatically drain collected water.
Ensure that the appliance is turned off and unplugged from the power source before setting up the drain
hose.
Remove the center drain plug and attach the drain hose that was provided with the appliance. Ensure that
there are no kinks or bends in the drain hose as this can stop water from draining.
Place the open end of the drain hose over the receptacle that the appliance will drain into; this could be a
basement fl oor drain, a sink or similar.
The drain pump used during heat mode means that the drain hose can be directed upward to a drain if
necessary. Ensure that the hose does not angle upward for more than 1.8 meters (6 feet).
3
≤1.8 m
16