A SYSTEMS DMP808 Manual Del Usuario página 14

DMP808 / DMP808D
If your DMP808 and your computer are connected through an existing local area network and not a set IP address,
please follow the steps below to establish a connection.
1. Make sure that your DMP808 and computer have
successfully connected to the local area network.
2. Select the executable file (.exe) inside the DMP808
Control Software folder.
3. Select at the login screen to search the current
IP address.
4. All the existing IP addresses will appear in the "Device
IP" drop-down box.
DSP
The DSP page will give you an overall idea of input and
output mixes (including levels and naming) as well as offer
a manner to view and edit the current signal processors
assigned to input and output channels.
Name: Edit the name for each of the individual input
channels.
On/Off: Use this button to switch the corresponding input
channel on and off.
Processing: These buttons allow you to inject any of the
DMP808's internal signal processors right into the input
chain. Processing will be accomplished in order from left
to right. For more information on the available programs,
check the Signal Processor section of this manual
Reset Button: Pushing these buttons will reset the DSP
parameters for the input or output, including name, on/off
status, and selected signal processors. There is a reset button available for each the input and output.
Monitoring: The DMP808 software offers extensive monitoring for DSP performance. The percentage of the processor
used will be visible at the bottom of the page.
English
5. Select the IP address that will be used for DMP808.
6. Enter the following information on the login page.
User Name: USER_1
Password: ASYSTEMS
7. Click to begin the installation.
12