A SYSTEMS DMP808 Manual Del Usuario página 23

RM-6E PROGRAMMABLE REMOTE
With a single RM-6E you will be able to control up to 6
independent functions including gain control, channel
muting and matrix mixing. Up to eight RM-6Es can be
utilized at any one time.
WIRING
The RM-6E has an "IN" port that
can be connected to the RJ-45
"Peripheral" connector on the
DMP808 series of digital matrix
amplifiers and processors. This
is done using a typical CAT5/6
cable.
A second RM-6E can then be
daisy-chained off the first by
connecting the "LINK" RJ-45
connector on the first to the "IN" connector on the second.
This can then be repeated for a third, a fourth, and so on.
You can use a maximum of 8 RM-6E's together with your
DMP808.
DMP808 / DMP808D
SETUP
The rear of the RM-6E features 3 DIP switches that can
be utilized for identification of the unit. These correspond
with the 8 ports available within the DMP808 software.
The pin identifications and their corresponding ports are
as follows:
1 2 3
PORT
DIP
To assign a function to any of the RM-6E's buttons, you
will need to enter the software of your DMP808. When in
the software, navigate to the "Global Settings" tab. Within
this menu there is an "RM Control" submenu that offers
control of the RM-6E programmable remote controls.
The "Port" option at the top of the page will correspond with
the port options found above. When the corresponding
port is selected, the 6 rows in the lower-half of the
page can be used to determine the operation of each
individual button on the RM-6E. Available functions are:
"Gain Control", "Channel In Mute", "Channel Out Mute"
and "Matrix Mixer". The first three functions also have
a "Source" option that simply lets you select from an
available channel that you can then control. The "Matrix
Mixer" function has further options, allowing you to select
from the applicable matrix mix and input source.
Below the "Port" option in the control software, there
is also a "Lock" option. When a port is "locked", the
corresponding functions of the RM-6E assigned to this
port will be deactivated and cannot be utilized using that
remote unit.
OPERATION
When a function is selected, pushing the RM-6E's
corresponding onboard buttons will activate said
function. In the case of "Gain Control", the up/down arrow
buttons are used to adjust the gain as needed. When a
"Mute" function is selected, simply pushing the button
will mute the selected channel/source. Finally, when the
Matrix function is selected, pushing the corresponding
button will route the signal selected to the mix selected.
Pushing it again will un-route the signal.
With up to 8 individual RM-6E units you're able to set a
maximum of 48 individual gain controls, channel mutes
and/or matrix routing presets for use at any time.
21
4 5 6 7 8
English