Optional Accessories - Makita HR4041C Manual De Instrucciones

MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
•
unplugged before attempting to perform inspection
or maintenance.
Never use gasoline, benzine, thinner, alcohol or the
•
like. Discoloration, deformation or cracks may
result.
Lubrication
This tool requires no hourly or daily lubrication because it
has a grease-packed lubrication system. It should be
relubricated after every 6 months of operation. Send the
complete tool to Makita Authorized or Factory Service
Center for this lubrication service.
1
007791
007888
Run the tool for several minutes to warm it up. Switch off
and unplug the tool.
Loosen three hex bolts which secure the crank cap cover
and remove the crank cap. Rest the tool on the table with
the bit end pointing upwards. This will allow the old
grease to collect inside the crank housing.
007792
Wipe out the old grease inside and replace with a fresh
grease (60 g; 2 oz). Use only Makita genuine hammer
grease (optional accessory). Filling with more than the
1. Hex bolt
2
3 2. Hex wrench
3. Crank cap cover
1. Crank cap
1
1. Hammer grease
1
specified amount of grease (approx. 60 g; 2 oz) can
cause faulty hammering action or tool failure. Fill only
with the specified amount of grease.
Reinstall the crank cap and crank cap cover and tighten
the three screws with the hex wrench.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized or Factory Service Centers, always
using Makita replacement parts.

OPTIONAL ACCESSORIES

CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons.
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Bull point
•
Cold chisel
•
Scaling chisel
•
Grooving chisel
•
Core bit
•
Center bit
•
Rod
•
Core bit adapter
•
Hammer grease
•
Depth gauge
•
Safety goggles
•
Plastic carrying case
•
Spline shank Carbide-tipped bits
•
Spline shank to A-Taper adapter
•
Spline shank to SDS adapter
•
Blow-out bulb
•
Lock nut wrench 35
•
Hex wrench
•
NOTE:
Some items in the list may be included in the tool
•
package as standard accessories. They may differ
from country to country.
7
or attachments
Only use accessory or
are