Publicidad
• Place a short spacer tube (41), a drive disk (8), a 5/8"
flat washer (33), another drive disk and a second 5/8" flat
washer onto the shaft. Fit the short spacer tube onto the
flanged bearing in the end plate. See figure 14.
FIGURE 14
• Place two spike disks (7), separated by a long spacer
tube (20), onto the shaft. Fit the long spacer tube onto the
ends of the flanged bearings in the disks. See figure 15.
20
7
FIGURE 15
8
41
33
• Place a 5/8" flat washer (33), the compression spring
(38) and another 5/8" flat washer onto the shaft. See
figure 16.
FIGURE 16
• Place two spike disks (7), separated by a long spacer
tube (20), onto the shaft. Fit the long spacer tube onto the
ends of the flanged bearings in the disks. See figure 17.
20
FIGURE 17
• Place two 5/8" flat washers (33) separated by a long
spacer tube (20) onto the shaft. See figure 18.
20
FIGURE 18
10
33
38
7
33
Publicidad
