Putting Into Operation - Bonnet Neve MULTITINY PLUS Instrucciones De Uso

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante
14. WATER COLLECTION TANK CLEANING
Attention! Clean based on use and need and in particular environmental conditions (e.g. high humidity, low
room temperature, presence of dust, etc.) to avoid incorrect and incomplete evaporation of water and/or
presence of unpleasant odours.
Check and clean periodically the tray sucking any dirt and/or remnants with a properly powerful
aspirator suitable for liquids.
15. MAINTENANCE
WARNING! Maintenance must be carried out by technical staff trained and enabled for intervention
on the flammable refrigerants.
WARNING! Any work carried out on the appliance by the user strictly requires the power plug being
disconnected from the mains socket.
ATTENTION! Use protective shoes and gloves during maintenance operations.
OPERATION
Cleaning of external surfaces
Cleaning of accessible internal parts (no use of tools)
Seals intactness check
Water collection tank cleaning
Checking and cleaning the condenser if necessary
Replacement components and parts
* Recommended frequency for optimal counter operation and maintenance of full efficiency.
Any other maintenance operation not planned in the previous points should be carried out by the
support centres authorised by our dealers or by qualified staff.

16. PUTTING INTO OPERATION

If the cabinet has been sharply tilted while being sited or for mounting of accessories, it must be left to stand for at least three hours
before being started to allow the lubricating oil to settle in the compressor.
Failure to do so can cause total destruction of the compressor refrigerating system.
Check that the voltage on the identification plate is the same as that of the network.
THE ELECTRICAL SUPPLY LINE TO WHICH THE REFRIGERATOR WILL HAVE TO BE CONNECTED
IS TO BE PROTECTED BY A VERY SENSITIVE DIFFERENTIAL SWITCH (Rc=16A,Dc=30mA);
IT IS ALSO TO BE LINKED TO THE GENERAL EARTHING PLANT.
Earthing is necessary and compulsory by law.
Absolutely never use reduction units, patch cords, adapters or multiple socket outlets to connect the
counter. DIRECTLY connect the equipment to the mains.
The cable should be fully extended and located where it is unilikely to be struck, caught or stepped on, away from water and the other
liquids and heat sources and must not be damaged. In case of breakage of the power cable of the cabinet, it must be replaced by the
manufacturer or by instruction it change of it.
Follow the manufacturer's instructions to install the unit, using qualified personnel and complying with the electrical regulations for
the specific country.
Incorrect installation may cause injury and damage; the manufacturer is not liable for this.
The manufacturer disclaims all responsability for any damage to people or things due to incorrect
observance of this rule.
MULTITINY PLUS
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
FREQUENCY
Based on use
Based on use
MAINTENANCE
Ordinary
Ordinary
Yearly * Ordinary
Yearly * Ordinary
Yearly * Ordinary
- Extraordinary
1 7 / 5 2
PAGE
UM000449
N° DOC
AUTHORISED STAFF
User
User
Technical support
Technical support
Technical support
Technical support