Energy Saving Tips - Bonnet Neve MULTITINY PLUS Instrucciones De Uso

Modello - Modèle - Model
Modell - Modelo
Fabbricante - Constructeur
Manufacturer - Hersteller
Fabricante

17. ENERGY SAVING TIPS

• Install the appliance in a dry, well-ventilated room away from heat sources (radiator, cooking surface and so on) and in a position
out of direct sunlight.
• Follow the installation instructions to ensure adequate ventilation. Insufficient ventilation to the back of the appliance causes an
increase in energy consumption and reduces cooling efficiency.
• The internal temperature of the appliance depends on the room temperature, how often the doors are opened and where the
appliance is placed. These factors have to be taken into account when setting the thermostat. Only open the doors when strictly
necessary.
• Let hot food and drink cool down before placing them in the appliance.
• The positioning of the shelves in the fridge has no effect on energy efficiency.
• The fridge compartment light system uses a LED light, which at the same time ensures more efficient lighting and reduced energy
consumption.
18. TEMPERATURE SETTING AND CONTROLS
Each refrigerating appliance is provided with an electronic control for automatic maintenance of the appropriate pre-established
temperature inside the tank.
This temperature adjuster is gauged by the factory and should not be touched by the user.
Only if the average internal temperature is too cold or not cold you can increment or decrement the temperature:
• Press the (Set) (2 sec.) key in order to see on display the temperature set point.
• Press the () key or the () key in order to increment or decrement the temperature set point.
• Press the (Set ) key in order to store the new temperature set point.
1
2
3
LED MODE
ON
Flashing
ON
Flashing
ON
Flashing
ON
ON
19. PROLONGED SWITCH OFF
When the unit is not used for a long time, please take note of the following procedures:
• Unplug the unit.
• Clean and dry the tank well.
• Leave the glass door open to avoid possible formation of bad odours.
• Cover the unit with a curtain, place it in a dry room and sheltered from the atmospheric agents.
MULTITINY PLUS
EPTA S.p.A. - Sede legale
Via Mecenate, 86 - 20138 Milano – Italy
Capitale € 68.515.000 - R.E.A./MI – 1730229
Registro delle Imprese e Cod.Fiscale n. 04160730968
Partita IVA 04160730968
4
5
MEANING
Active compressor
Delay against close starts
Defrosting in progress
Dripping in progress
Fans on
Fans start delay in progress
A temperature alarm activated
Continuous cycle in progress
1. Light switch
2. Manual defrosting button
3. Button to show set temperature
4. Button to decrease temperature
5. Button to increase temperature
LED MODE
ON
ON
ON
ON
°C
Flashing
ECO
ON
1 8 / 5 2
PAGE
UM000449
N° DOC
MEANING
Energy saving in progress
Light on
Auxiliary active
Unit of measurement
Programming
Energy saving in process