Forney 325P Manual De Instrucciones página 6

• Do not weld in a damp area or come in contact with a moist or wet surface.
• Do not attempt to weld if any part of clothing or body is wet.
• Do not allow the welding equipment to come in contact with water or moisture.
• Do not drag welding cables, wire feed gun, or welder power cord through or allow them to
come into contact with water or moisture.
• Do not touch welder, attempt to turn welder on or off if any part of the body or clothing is
moist or if you are in physical contact with water or moisture.
• Do not attempt to plug the welder into the power source if any part of body or cloth ing is
moist, or if you are in physical con tact with water or moisture.
• Do not connect welder work piece clamp to or weld on electrical conduit.
• Do not alter power cord or power cord plug in any way.
• Do not attempt to plug the welder into the power source if the ground prong on power cord
plug is bent over, broken off, or missing.
• Do not allow the welder to be connected to the power source or attempt to weld if the welder,
welding cables, welding site, or welder power cord are exposed to any form of atmospheric
precipitation, or salt water spray.
• Do not carry coiled welding cables around shoulders, or any other part of the body, when
they are plugged into the welder.
• Do not modify any wiring, ground connections, switches, or fuses in this welding equipment.
• Wear welding gloves to help insulate hands from welding circuit.
• Keep all liquid containers far enough away from the welder and work area so that if spilled,
the liquid cannot possibly come in contact with any part of the welder or electrical welding
circuit.
• Replace any cracked or damaged parts that are insulated or act as insulators such as
welding cables, power cord, or electrode holder immediately.
• When not welding, cut wire back to contact tip or remove electrode from electrode holder.
SIGNIFICANT DC VOLTAGE EXISTS ON INTERNAL PARTS OF INVERTER POWER
SOURCES AFTER THE REMOVAL OF INPUT POWER.
Turn Off unit, disconnect input power, check voltage on input capacitors, and be sure it is
near zero (0) volts before touching any parts. Check capacitors according to instructions in
Maintenance Section of Owner's Manual or Technical Manual before touching any parts.
EXPLODING PARTS CAN INJURE.
On inverter power sources, failed parts can explode or cause other parts to explode when
power is applied. Always wear a face shield and long sleeves when servicing inverters.
FLYING SPARKS CAN CAUSE INJURY.
• Wear approved face shield or safety goggles with side shields.
• Wear proper body protection to protect skin. Wear flame-resistant ear plugs or ear muffs to
prevent sparks from entering ears.
ARC RAYS CAN BURN EYES AND SKIN.
Arc rays from the cutting process produce intense visible and invisible (ultraviolet and infrared
rays that can burn eyes and skin.
• Wear face protection (helmet or shield) with correct shade of filter to protect your face and
eyes when cutting or watching.
• Wear approved safety glasses with side shields under your helmet or shield.
• Use protective screens or barriers to protect others from flash and glare; warn others not to watch
the arc.
• Refer to ANSI Z49.1 for OSHA 29CFR for shade recommendations.
6
WWW.FORNEYIND.COM