Seat Height; Back Rest; Adjusting The Angle; Arm Rest - B+B Centuro S7 Manual De Instrucciones

Centuro S7
| Scooter
Moving the seat
• Pull the lever (on the right below the seat surface, Fig. 05) towards
you. The seat can now be moved forwards and backwards.
• You can now adjust the seat to the required position.
• Release the lever and ensure that the seat is locked in one of the
closest fixed
05

Seat height

You will firstly need to remove the seat.
• Fold the back rest onto the seat by holding the back rest with your
right hand and using your left hand to lift up the lever on the
left next to the seat surface (Fig. 08). The back rest will then fold
forwards automatically.
• Simply remove the seat by pulling it upwards (Fig. 6).
• Undo the screw connection (Fig. 7) and position the seatpost in the
06
required position inside the tube guide.
• Then securely tighten the screw connection again (Fig. 7) using
40Nm in the next hole.
• Now place the seat back onto the mounting.
• Make sure that it is locked in position again.

3.5.4. Back rest

07
The angle of the back rest on your scooter can be adjusted forwards
and backwards. You also have the possibilty to limit the adjustment
range backwards

Adjusting the angle

• Pull the lever (on the left on the seat, Fig. 08) upwards. The back
now pushes forwards.
• Push the back rest into the required position.
• Release the lever and make sure that the back rest is locked in
08
position again.
• Please note that the adjustment of the seat to the rear and/or the
angle adjustment to the rear can increase the overall length of the
scooter.
48
positions.

3.5.5. Arm rest

The arm rests can be swivelled upwards in order to make it easier to
mount and dismount. In addition, the height, distance and angle of the
arm rests can be adjusted.
Height
• Loosen the screw until you can remove it, hold the screw in its
position. Now you can move the arm rest vertically up and down
(Fig. 9).
• Move the arm rest to its preferred height and tighten the screw.
Side distance
• Undo the hand screw (Fig. 10) on the back of the back rest frame
while holding onto the armrest.
• Adjust to the required distance and tighten the screw again.
• The armrests can also be removed (e.g. for replacement, storage or
transportation) after undoing the screw on the back of the frame
(Fig. 10).
• Please note that pulling the armrests out to the side can increase
the vehicle width.
Angle of support
• You can adjust the angle of support of the armrests by screwing
the knurled nut (Fig. 11) on the relevant armrest further in or by
unscrewing it.

3.5.6. Seat belt (optional)

The seat belt will be attached to the frame from the side.
• Adjust the belt length to meet your needs by positioning the clasp
accordingly.
• Fasten the belt with the belt buckle.
• Unfasten the belt by pressing the red button (Fig. 12) on the belt
buckle
Bischoff & Bischoff GmbH |21.07.2020 - revision 3
Centuro S7
Scooter |
09
10
11
12
49