Extinguishing The Fire; Removing Ash - Dru 55MF Instrucciones De Instalacion Y Uso

Advice
Never burn wood with an open door.
Regularly burn wood with intense roaring fires.
If you burn at a low setting frequently, tar and
creosote may be deposited in the flue. Tar and
creosote are highly combustible substances.
Thicker layers of these substances may catch
fire if the temperature in the flue increases
suddenly. By allowing the fire to burn very
intensely regularly, layers of tar and creosote
will disappear.
Low intensity fires can also cause tar deposits
on the stove window and door.
When the outside temperature is mild, it is
better to burn wood intensely for a few hours
instead of having a low intensity fire for a long
period of time.
Regulate the air supply using the secondary air
inlet.
The secondary air inlet not only supplies air to
the fire but to the glass as well, so that it does
not quickly become dirty.
Open the primary air inlet for the time being if the air
supply by the secondary air inlet is inadequate or if
you want to fan the fire.
Topping up with a few logs regularly is better than
adding many logs in one go.

Extinguishing the fire

Do not add fuel and just let the fire go out. If a fire is
damped down by reducing the air supply, harmful
substances will be released. For this reason, the fire
should be allowed to go out naturally. Keep an eye on
the fire until it has gone out. All air inlets can be closed
once the fire has died completely.

Removing ash

After wood has been burnt, a relatively small amount
of ash remains. This ash bed is a good insulating layer
for the stove base plate and improves combustion. It
is a good idea to leave a thin layer of ash on the stove
base plate.
However, the flow of air through the fire plate must not
be obstructed and no ash may be allowed to
Subject to change because of technical improvements
accumulate behind a chamotte inner plate. Remove
the excess ash regularly.
A relatively large amount of ash is left over after
burning brown coal briquettes and anthracite coal. No
ash may be allowed to accumulate underneath the fire
grate and the ash should never reach the bottom of the
grate. This will cause the grate to overheat and be
damaged.
3 1
1. Use the riddling rod to free the grate (3) of excess
ashes.
If the appliance is still hot, use the "cold hand"
to operate the riddling rod.
2. Open the door of the appliance.
3. Use the scraper (1) to sweep the remaining ashes
through the grid.
4. Remove the ash pan (2) using the glove provided.
5. Empty the ash pan.
6. Put the ash pan back into the appliance.
7. Close the door of the appliance.
2
09-20021-059
15