Chapter 1. General Description Technical Characteristics - gala gar D-20 C Manual De Instrucciones

CHAPTER 1. GENERAL DESCRIPTION. TECHNICAL CHARACTERISTICS.
These wire-feed units forms part of a modular system (INDUSTRIAL GALA) that permits electric welding of
carbon steels, slightly alloyed steels, stainless steels and aluminium, which are the most commonly used
metals in modern industry, by means of the MIG-MAG semiautomatic procedure.
The whole modular system that makes up the installation comprises the following elements:
1.1 – Power source. (Earth cable included).
1.2 – Wire-feed unit (Independent from the power source).
1.3 - Connection extension lead between power source and wire-feed unit. Welding torch.
1.4 - Cooling module for cooled welding gun.
1.5 - Transport trolley (compulsory if a cooling module is installed) or bottle support.
1.6 - Auxiliary elements: Pressure reducing valve for gas bottle, gas economiser.
1.1. WIRE-FEED UNIT D-20C (CLOSED, FOR WIRE REEL OF 5 kg, WITH ROTAMETER).
Closed wire-feed unit for wire reels of 5 kg. Drive motor with two geared 30 mm φ rollers. Wire speed and
welding voltage control (Electronic power sources). It incorporates rotameter to adjust and measure the
protection gas flow. Possibility of incorporating an cooling unit. It can be incorporated into any power source
from the GALA INDUSTRIAL line.
D-20 C (V-I): It incorporates system of digital measurement of weld parameters.
TABLE 1. Basic technical characteristics of the Wire-feed unit D-20 C / D-20 C (V-I)
SUPPLY VOLTAGE U
MAXIMUM INPUT INTENSITY I
No. OF GEARED DRIVING ROLLERS
APPLICABLE WIRE DIAMETERS (mm.)
WIRE REELS
DRIVING MOTOR
MAXIMUM WIRE SPEED (m/min.)
MAXIMUM WELDING INTENSITY I
NOMINAL WELDING INTENSITY I
COOLING CIRCUIT OF TORCH
WELDING VOLTAGE CONTROL
ROTAMETER
MEASUREMENT WELD PARAMETERS
2S/4S PULSATION SYSTEM
MOTOR-SOLENOID VALVE BLEEDING
FINAL WIRE LENGTH CONTROL
ANTI-ARCING RAMP CONTROL
WEIGHT
Fig. 1 – General dimensions of D-20C /D-20C (V-I) equipment.
Standard equipment supplied with:
D-20 C: Drive rollers
-
D-20C / D-20C (V-I)
TECHNICAL CHARACTERISTICS.
1
1max
2max
2100%
30mm 1.0/1.2. Instructions manual.
φ
Ref. 623.00.000 Ref. 623.81.000
D-20 C D-20 C (V-I)
24 V 50/60 Hz. 24 V 50/60 Hz.
5 A
4 x φ 30mm 4 x φ 30mm
UP TO φ 2.0mm. UP TO φ 2.0mm.
φmm; 5 kg φmm; 5 kg
24 V=; 100 W 24 V=; 100 W
19 m/min. 19 m/min.
450 A/ 60% 450 A/ 60%
350 A/ 100% 350 A/ 100%
OPTIONAL KIT OPTIONAL KIT
YES
YES
---
YES
YES
YES
YES
11 Kg. 11.5 Kg.
10
5 A
YES
YES
YES
YES
YES
YES
YES