Super Ego ANGLE-78 Manual De Instrucciones página 16

Start up the angle grinder
GB
1. Remove the packaging
Pay attention to the electric capacity
The voltage of the power source must agree with the specifications on the label.
Machines labeled with 230/120 V can also be operated with 220/110 V
ADVICE!
2. Attaching the handle
- Screw the handle (1) into one of the corresponding threaded holes (5) left, right or above, according to
how you can hold the machine most comfortably.
- The machine may not be operated without a handle. Always hold the machine with both hands! The
handle can easily be detached by turning it.
- Make sure that the handle is completely fastened when working..
3. Mounting the protection cover
- As the case may be, when using the machine, the protection cover must the set so that you are protected
from flying splinters or sparks.
- Adjust the protection cover by simply turning it powerfully. The protection cover can be turned about +-60º.
- The protection cover protects you from flying splinters when it is turned toward you.
- Here, make sure that your hands are protected.
4. Grinding discs
- Only use grinding tools whose allowable rotation speed is at least as high as the highest idle running
rotation speed of the machine. The allowable perimeter speed of the discs must be 80m/s. read the
perimeter speed on the label of the disc being used.
- Allow the new separating disc to run idle for about one minute in a test run.
- Vibrating discs may not be used. Protect the discs from blows, crushes, as well as oil.
5. Mounting the grinding discs
Danger of burning!
Grinding and separating discs will become very hot during operation. They could catch fire.
ADVICE!
Danger of injury! Before all adjustments and settings:
- Turn the machine off.
- Pull out the power plug
DANGER!
- Wail until the machine is still
- Change the disc after they have cooled down.
- Clean the wheel flange (10), the clamping nut (14), and the metal clamping surface (13) of the grinding
dis.
- Attach the wheel flange (10) with the longitudinal slot underneath on the grinding spindle (8).
- Attach the grinding wheel (12). The wheel flange (10) has a high central band with a rubber ring; this
must engage exactly in the hole of the grinding disc (13).
- Press the spindle locking device (4).
- Turn the grinding disc (12)/grinding spindle (8) until the spindle locking device locks.
- Screw on the clamping nut (14) and tighten it with the hook wrench (15)
- Check before turning the machine on, that the grinding disc rotates freely.
16