GE Advantium ZSC1001 Manual Del Usuario página 5

IMPORTANT:
Always maintain 36-3/4" minimum height from the floor to the cutout in any single or
combined installation.
PREPARE THE OPENING
The Advantium 120 can be installed in
combination with other GE Appliances/
Monogram appliances. Always follow each
product's Installation Instructions to complete the
installation.
Single Advantium 120 Installation:
Order a 27" or 30" wide single oven cabinet
or cut the opening in a wall to the dimensions
shown.
27" or 30"
17-1/2"
36-3/4"
Min.
• Allow 1-1/4" case trim overlap at the top and
7/8" overlap on the bottom and each side of the
opening.
• Oven overlaps will conceal cut edges on all
sides of the opening.
When installed over a single oven or a
warming drawer, allow at least 2" between
the two openings. This separation will provide
clearance for bottom overlap of the Advantium
120 and the other appliance overlaps.
• The support must be level and rigidly mounted,
flush with the bottom edge of the cutout.
Standard Installation Preparation
23-1/2"
25-1/4"
Construct
solid bottom
- Min. 3/8"
plywood
supported
on all four
sides. Must
be able to
support
weight of
oven and
contents.
PREPARE THE OPENING
Installation over a GE Appliances/
Monogram Warming Drawer:
27" or 30"
17-1/2"
36-3/4"
Min.
may be required. Check to be sure the oven
supports above the Warming Drawer location does not
obstruct the required interior depth and height. See
Warming Drawer installation instructions for details.
PREPARE THE OPENING
Installation over a GE Appliances/
Monogram Oven:
27" or 30"
17-1/2"
45-1/4"
Min.
double oven with the combined installation of an
Advantium 120 and a single oven, use the dimensions shown.
The middle rail separating the two openings may need to be
larger than the 2" minimum shown.
5
(CONT.)
Construct
23-1/2" solid bottom
- Min. 3/8"
plywood
supported
on all four sides.
Must be able to
support weight
25-1/4"
of oven and
contents.
2 Min.
(3 Recommended)
Per Warming
Drawer
Requirement
NOTE: Additional
clearances between the cutouts
(CONT.)
23-1/2"
Construct
solid bottom - Min.
3/8" plywood
supported
on all four sides.
Must be able to
25-1/4" support weight
of oven and
contents.
2 Min.
(3 Recommended)
Per Oven
Requirement
NOTE: If you are replacing a
GE Appliances/Monogram electric