Slave Mode - Metz MECABLITZ 15 MS-1 digital Manual De Instrucciones

5.2 Slave mode

"Slave mode" reflects the setting that
has been learnt in the "Learn func-
tion". This function is retained until a
"Learn function" or a "RESET" is per-
formed again.
Adjustment of the flash unit
• Activate the camera flash unit.
• Slide the infrared clamp over the
camera's own flash unit if it is to be
used as controller flash unit. Swivel
external flash unit so that it cannot
contribute to lighting.
• Switch-on flash unit with the main
switch .
• Keep the button "AF/SELECT"
the flash unit pressed until the follo-
wing message appears in the
display:
S E L
• Press the button
unit. In the display appears:
15MS-1
on
S E L E C T
S E L
M O D E L L I N G
on the flash
L I G H T
O F F O N
S E L
• Press the button
unit. The most recently used setting
appears in the display, e.g.:
• Press the button
SLAVE" appears in the display.
• Press the button and the SLAVE
OK
mode is set with a ratio of 1:1 bet-
ween both the reflectors and full
lighting power (Power) 1/1.
Following display appears:
• If both reflectors should be set at an
unequal ratio (Ratio) then press the
button or
The ratio can be adjusted in steps. In
the display appears, for example
V 1 . 0
• If you wish to use partial lighting,
then press the button
Following display appears:
• To set partial lighting, press the but-
⊃
tons or
value. In the display appears, for
example.
OK
The setting thus made will be automa-
tically saved.
S E L on the flash
SYSTEM
NIK REMOTE
Ch ALL Gr A
until "SYSTEM SYSTEM
S L AV E
SL
SL
to change the ratio.
SL
P / R .
and thus change the
SL
S E L
OK
S E L
OK
Ratio
1:1
P / R
Ratio
4:1
P / R
Power
1/1
P / R
Power
1/4
P / R
79