Kicker CX.4 Serie Manual Del Propietário página 3

VERTICAL MOUNTING
amplifi er end panel
The CX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereo's source unit. A high-level signal can be run from the source unit's speaker outputs to the
stereo RCA input on the end panel of the amplifi er using the KICKER KISL as shown (make sure you set the CX
amplifi er's input level switch to "HI"). Alternatively, the signal can be delivered to the amplifi er using the low-level
RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to "LO". Keep the
audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring,
cross it at a 90 degree angle.
source unit core conductor
high-level speaker
outputs
+
–
Install a fuse within 18" (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you
ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
Model External Fuse
(sold separately)
CXA300.4 1 x 40 Ampere
2016 CX 4-Channel Amps Rev E.indd 3 2016 CX 4-Channel Amps Rev E.indd 3
hex screws
shield
Power/Ground Wire
8 Gauge
double-slotted
bracket
to amplifi er KICKER KISL (optional)
OR
KICKER Wiring Kit
PK8, ZCK84
to amplifi er
from source unit high-
level speaker outputs
3
9/29/2015 3:16:00 PM 9/29/2015 3:16:00 PM