Concluding Treatment - Beurer FM 150 Pro Instrucciones De Uso

7. The intensity is adjusted using the air pressure control-
ler. Start at the lowest level so that you get used to the
massage gradually.
For best effects the intensity should be set high, but at
a level where it is still comfortable.
8. Press „timer" button to switch among three kinds of
timing time which are 10 minutes, 20 minutes and 30
minutes. When start up, the default is 20 minutes. When
the remaining time is 5 minutes, the current time indica-
tor slowly flashes; when the remaining time is 1 minute,
the current time indicator quickly flashes.
9. In the process of using, if you feel the pressure is too
much or not comfortable, press the „stop" button to
stop the treatment.
Note
The device will now start to massage the legs alternately. The legs will never be massaged at the same
time. This is not an indication that the device is faulty.
The device features an automatic switch-off function, which is set to the maximum operating duration of 30
minutes.
If the batteries are almost flat, the timer LEDs begin to flash from right to left. The device will switch off after a
few seconds and then be in a 30-second stand-by mode. During this time, all 3 timer LEDs light up.

8.2 Concluding treatment

To stop the treatment, you should first switch the device off and then let the air out of the cuffs.
Proceed as follows:
1. Switch the device off by pressing the ON/OFF
button on the hand switch. The set timer LED
goes out. The device is now in standby mode
for 30 seconds. During this time, all 3 timer
LEDs will be activated.
stop
20
stop
stop
stop
stop stop