Starting The Engine - Efco MP 3000 Manual De Instrucciones

OPERATION

Starting The Engine

20
Fill the carburettor by pushing primer bulb (A, Fig.20). Make sure
that the throttle (B, Fig.22) works properly, rotating between MIN
and MAX. Put the ON/OFF switch in the MIN position (B, Fig.21).
Put choke lever (C, Fig.20) on CLOSE position (only for cold
engine). Holding the unit firmly, pull the starter handle until you
meet resistance, then pull quickly with a short sharp stroke.
Repeat this until the engine fires. Put then the choke lever (C,
Fig.23) in OPEN position and pull the starter handle again till the
engine starts. After starting, warm up the motor before increasing
the RPM to the required value. During use, when a high number
of RPM is no longer necessary, move the accelerator (B, Fig.21)
21
to the minimum (MIN).
WARNING! - Do not use the choke (C, Fig. 20) when
starting a hot engine.
NOTE - STARTING WARM ENGINE:
Follow above starting instructions, but do not use the Close
Choke position for start up again. To set fast idle for warm
engine starting, pull choke out completely and push back in
22
to the original Open Choke Position.
WARNING: Weather conditions and altitude may
affect carburetion. Do not allow bystanders close to
the water pump while adjusting the carburetor.
23
en
13