How To Operate Your Tr28 Hand-Held Remote; Installing The Canopy Housing; Maintenance; Blade Cleaning - Fanimation The Air Shadow FP820 Serie Manual Del Propietário

How to Operate Your TR28 Hand-held Remote

1. Operating & Using Remote Transmitter (Figure 1):
Install two piece of 3 volt battery (If not using for long
periods of time, remove battery to prevent damage to
transmitter). Store the transmitter away from excess heat
or humidity.
• HI Push Button – high fan speed
• MED Push Button – medium fan speed
• LOW Push Button – low fan speed
• Push Button – fan off
• REV Push Button – toggles between air upflow and
air downflow
• *Demo Push Button – on/off auto demo mode
• Light Push Button – on/off and brightness control for
optional down light.
To control either light hold down key to increase or
decrease brightness. Tap key quickly to turn light on or
off. The light keys have auto resume and will stay at the
same brightness as the last time it was turned off.
NOTE: This step is applicable after the neccessary wiring
is completed. (see page 7)
▲WARNING
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy housing
and not pinched between the housing and the ceiling.
1. Screw in two threaded rods into the Hanger Bracket
(Figure 1a).
NOTE: The threaded rods in the hanger bracket serve as
guides for easier installation.
2. Securely attach the Canopy Housing to the Hanger
Bracket using the external lockwashers and knurled knobs
supplied with your fan (Figure 1b).
Periodic cleaning of your new ceiling fan is the only
maintenance that is needed.
When cleaning, use only a soft brush or lint free cloth to
a v o d i c s a r c t h n i g h t e f n i s i
Abrasive cleaning agents are not required and should be
avoided to prevent damage to finish.
Periodic light dusting of the blades is recommended.
A feather duster will work best.

Installing the Canopy Housing

Maintenance

. h

Blade Cleaning

3V, CR2032
BATTERY
2 PCS
*Demo mode is initiated by pressing the Demo button
on the remote, lights will fiash 3 times. Fan runs for 2½
minutes then shuts off for ½ minute. The 2 ½ / ½ minute
run cycles continue until any other button is pressed on
the remote control.
NOTE: Supply wires and fan wires omitted for clarity.
Figure 1a
CAUTION
Do not use water when cleaning your ceiling fan. It could
damage the motor or the finish and create the possibility
of electrical shock.
Avoid using water, cleansers, or harsh rags, which can
w a p r a n d u r n i h t e b a l d
8
Figure 1
Figure 1b
e a n d h t e f n i s i . h