Overlay Door Panel Installation - AGA marvel MA15CL Instrucciones De Instalación, Operación Y Mantenimiento

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

CAUTION

Step 1: Verify door alignment

Verify that the door is aligned correctly with the cabinet

prior to fabricating the custom panel. Failure to do so

may result in mis-alignment of the custom panel with the

hinge bracket. The door should be parallel to the sides

and top of the ice machine. If alignment is necessary

the door may be adjusted by loosening the 2 screws

which secure the top and/or bottom hinge adapter

brackets, located on the top and bottom of the door and

adjusting the door side to side. Use a

for this procedure. (See Figure 30 below). When fin-

ished aligning the door, tighten the screws securely.

Hinge adapter bracket

located on the top and bot-

tom of the door.

Figure 30

Step 2: Remove door

Remove the top hinge pin from the hinge with an 1/8" allen

wrench. Remove the door by angling the top of the door

outward and lifting the door off the bottom hinge.

(See detail in Figure 30).

Step 3: Remove gasket

Lay the door on its front being careful not to scratch it. To

gain access to the screw mounting holes remove the door

gasket by peeling up and out of the channel.