Drain Pump - AGA marvel MA15CL Instrucciones De Instalación, Operación Y Mantenimiento

With a factory installed drain pump:
The Marvel Drain Pump is designed to remove drain water
from ice machines installed in areas without direct drainage
access. The sealed reservoir pump collects the melted ice
water and pumps it to a maximum lift of eight (8) feet (2.44
meters) using no more than the 20 feet of
ing.
If the ice machine has a factory installed drain pump. Dis-
charge tubing is coiled up and attached to the back of the
ice machine. The ⁄ inch I.D. tubing needs to be plumbed
3
8
and connected to a sanitary sewer. Refer to Figure 10.
CAUTION
!
This drain pump is designed to be installed in Marvel ice
machines only and is approved for use with water only.
WARNING
!
Electrical Shock Hazard
Risk of electrcal shock or personal injury could occur
due to moving components, if the machine compart-
ment access cover is removed before unplugging the
ice machine power cord.
INSTALLING THE DRAIN PLUMBING
⁄ " I.D. vinyl tub-
3
8
Optional Drain Pump.
An optional drain pump is available if you have purchased
an ice machine without one and do not have access to a
gravity drain. Installation instructions are provided with the
optional drain pump. Contact AGA Marvel customer service
at 800-223-3900 or your dealer for ordering.

Drain pump

vent tube.
Keep this
open to
assure air
flows freely
as water
enters the
pump reser-
voir.
Figure 10
7
Drain line coiled and
secured to the back of the
cabinet. Uncoil, route to
an appropriate drain and
cut to length.