Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Features
Web Management Card
A
Ethernet Port: RJ45 jack connects the WEBCARDLX to the network using a standard
Ethernet patch cable. LEDs
table below).
B
RJ45 Configuration Port: Use this port to provide a direct terminal connection to a
computer with a terminal emulation program. An RJ45 to DB9 cable (part number
73-1243) is included with the PDU. To request a replacement cable, visit www.tripplite.
com for ordering information.
C
USB Type-A Port: Use this port to connect a Tripp Lite EnviroSense2 module (E2MT,
E2MTDO, E2MTDI, E2MTHDI) for a variety of environmental monitoring and control options.
See www.tripplite.com for more information about these modules.
Note: Do not connect a keyboard or mouse to this port.
D
Reset Button: Accessible through a small hole on the faceplate above the RJ45
Configuration Port. Press once to reset the Web Management Card. Press and hold for 15
seconds to reset the Web Management Card to factory default settings.
Note: PDU loads will not be affected.
E
Status LED: Shows Web Management Card status (shown in the table below).
Identifier LED Function
Ethernet Link/
A1
Activity Indicator
Ethernet Network
A2
Speed Indicator
Web
E
Management
Card Status
16-10-210-933667.indb 10
D
E
C
B
A1
and
A2
indicate the operating conditions (shown in the
LED Color
Status
Green
Flashing
Off
Yellow
On steady
Off
Off
Green
On steady
Green
Single
flash
Green/
Off
Orange
Green/
Alternating
Orange
(~1/sec.)
Green/
Alternating
Orange
(~2/sec.)
10
A1 A2
A
Description
There is network activity on the port
There is no network activity on the port
100 Mbps network speed
10 Mbps speed if
is flashing
A1
No network activity if
A1
Normal operation
Power up indicator
No power or card is initializing
Software update in progress
Restoring factory default
configuration
is also off
12/19/2016 4:26:21 PM
Publicidad
Tabla de contenido
