Alternate Mounting; Specifications - Tripp-Lite SmartRack SRW18US13 Manual Del Propietário

7. Equipment Installation
7.2 Alternate Mounting: Tapped Hole Mounting Rail
The 2 mounting rails are pre-installed for securing equipment using the square hole side of the mounting rail. To switch to the tapped hole side of the
mounting rail, follow the steps below:
Each rail is connected to the enclosure with 2 screws: 1 in the upper corner and another in the
1
lower corner. Using a Phillips-head screwdriver, remove the screws that fasten the rails to the
enclosure.
2 Switch the rail locations. Ensure the tapped hole side of each rail is facing the front door.
Reattach the mounting rails.
3
Use the included silver mounting screws to secure your equipment to the rack rail. Place the
4
cup washers between the screws and the equipment mounting brackets.
Note: Your equipment may also include mounting hardware. Read the mounting instructions that came
with your equipment before installing your equipment.

8. Specifications

Model
Dimensions (H x W x D)
Unit Weight
Load Capacity*
* Full wall-mount load capacity requires a mounting surface capable of bearing the full load.
12-11-206-93-3281.indd 7
( continued )
SRW18US13
35.6" (905 mm) x 23.6" (600 mm) x 13" (330.2 mm)
83.8 lb (38 kg)
250 lb (113 kg) Stationary
7
TOP RAIL
BOTTOM RAIL
1
2
TOP RAIL
BOTTOM RAIL
3
2
4
12/21/2012 2:38:22 PM