Assembly And Settings - Nilox DOC E-BIKE X3 Manual Del Propietário

ASSEMBLY AND SETTINGS

DOC E-BIKE X3 should reach you fully assembled, with the exclusion of the PEDALS, which are supplied
separately.
Nevertheless, some parts (such as the saddle and handlebar) may arrive disassembled, or in some way
require adjusting.
HANDLEBAR
Place the handlebar in the centre of the stem at the desired height.
Firmly tighten the hex head socket screws present as indicated by the
arrows.
ATTENTION! CHECK THE CORRECT POSITIONING OF THE FORK WITH
RESPECT TO THE HANDLEBAR.
IT MUST BE FACING TOWARDS THE FRONT.
IF THIS IS NOT THE CASE, YOU WILL BE UNABLE TO FIT THE WHEEL ON.
PEDALS
The pedals will arrive disassembled and in a separate plastic bag.
Carefully screw the pedals into the dedicated seat and tighten with
the spanner supplied.
CAUTION: In order to avoid them coming loose during travel, the
pedals (of all bicycles) have the characteristic feature of having the
SADDLE
Insert the sleeve of the saddle in its housing and adjust the height
and tilt, by turning the screws and quick-release terminals, as shown
in the figure.
left pedal with opposite thread.
In practice, when you screw them in, you will
need to do so in the opposite direction, as
though you were unscrewing.
EN
4