1. SAFETY
Warning for the safety of persons and objects.
Whenever the following symbols appear
beside a paragraph, they indicate the possibility of
danger if the corresponding instructions are not
followed.
DANGER
If this instruction is not
heeded, there is a risk of
risk of
electrocution.
electrocution
DANGER
If this instruction is not
heeded, there is a risk of
injury to persons.
ATTENTION
If this instruction is not
heeded, there is a risk of
damaging the equipment or
the installation.
1.1 Basic advice on safety and prevention of
damage
It is essential that both the fitter and the user
should read the manual and equipment
instructions before fitting and start-up, in
order to ensure their own safety, the safety of
other persons and the optimum operation of
the equipment.
The user must keep the manual and the
safety
labels
in
subsequent use.
DANGER, risk of electrocution
Take maximum precautions when handling
the equipment, since it is connected to the
mains and it contains water (an excellent
conductor of electricity).
Before performing any operation on the
pump, it is essential to disconnect the power
supply.
DANGER power cable
Position the power cable so that it cannot be
trodden on, perforated or damaged with any
object situated near it.
Carry out the installation in accordance with
the safety instructions for swimming pools
and the particular instructions for the pump
and
selector
valve
respective manuals).
The safety regulations in effect must be
observed when installing the equipment.
Maximum pressure of the equipment 2,5bar.
Do not connect directly to the drinking water
mains.
PROHIBITED handling or repair
The equipment may only be handled or
repaired by official technical services.
The user may only handle the equipment as
indicated in this manual.
The manufacturer accepts no responsibility
for any other handling of the equipment by
the user
good
condition
for
(supplied
with
the
8
ATTENTION cleaning
Always clean with a damp cloth and a neutral
soap solution. Do not use products that
contain solvents or acids.
ATTENTION heat
Position the unit away from heat sources or
exposure to the sun.
The equipment has been designed for
operation in technical premises.
ATTENTION
Only use the equipment for the filtration of
water in domestic swimming pools or small
ponds.
The equipment has been designed for
operation
with
temperature must be below 35ºC.
ATTENTION ventilation
Install the unit in such a way that its position
does not prevent the flow of air in and out of
the ventilator part of the pump. It must not be
installed inside furniture or cupboards which
prevent the free flow of air around the unit.
Do not start the pump connected to the pool
bottom cleaner, if the latter is not immersed
in water. Do not run the pump dry. The water
level of the swimming pool must not be lower
than that of the skimmer.
ATTENTION periods when not in use
When the unit is not to be used over a period
of time, disconnect the current collector on its
base. Take special care to close the shut-off
valve through which water is supplied to the
filtration unit and to empty the water
contained in the filter and pump.
2. GENERAL OBSERVATIONS
The filtration unit is an essential device for
maintaining the quality of the water in a swimming
pool over a long period of time, both for the
convenience of bathers and to save water
consumption, since the water does not need to be
replaced.
The function of the unit is the mechanical
separation of the solid particles in the swimming
pool water: these are retained in the filtering
medium.
The filtering element consists of small grains of
silicon sand, which are capable of retaining the dirt
dissolved in the water.
As the water is filtered, the dirt adheres more and
more to the grains of sand, reducing the passage of
water and consequently the volume of water in the
swimming pool.
In order that the water is correctly regenerated, it is
recommended that the entire contents of the
swimming pool are filtered at least 4 times a day.
EN
clean
water
and
the