Connecting The Cash Drawer - Citizen CT-S601 II Manual De Usuario

3.6 Connecting the Cash Drawer

1. Turn off the power.
2. Confirm the orien tation of the cash draw er kick-ou t cable connector and connect it
to the cash draw er kick-ou t connector at the back of the printer.
3. Remove the screw for the grou nd wire.
4. Screw the cash drawer's gro und wire to the body of the printer.
Cash drawer kick-out
Cash drawer kick-out cable
connector
CAUTION
 Connect only the cash drawer kick-out cable connector to the cash drawer kick-out
connector. (Do not connect a telephone line.)
 Signals cannot be output from the cash drawer kick-out connector while printing.
(1) Connector pin configuration
No. Signa l
1 FG
2 DRAWER1
3 DRSW
4 VDR
5 DRAWER2
6 GND
(2) Electric characteristics
1) Drive voltage: 24 VDC
2) Drive current: Approx. 1 A max. (not to exceed 510 ms.)
3) DRSW signal: Signal levels: "L" = 0 to 0.8 V, "H" = 2 to 3.3 V
(3) DRSW signal
DRSW signal status can be tested with the DLE+EOT, GS+a, or GS+r
command or at pin 34 on the parallel interface port.
Calle Llanos de Jerez 18 Nave 9 Coslada https://v10consumibles.com Tel: 910 269 309
connector
Function
Frame ground
Cash drawer 1 drive signal
Cash drawer switch input
Cash drawer drive power supply
Cash drawer 2 drive signal
Signal ground (common ground on
circuits)
V10 CONSUMIBLES S.L.
— 30 —
Ground wire
Screw for ground
wire
Connector used:
TM5RJ3-66 (Hirose) or
equivalent
Applicable connector:
TM3P-66P (Hirose) or
equivalent