Placing The Speakers - Yamaha NS-B700 Manual De Instrucciones

PLACING THE
SPEAKERS
■Using as 2ch stereo speakers
Better stereo images will be obtained when the speakers are
slightly angled in towards the listeners.
■Using as front speakers in a multi channel
system
Position the speakers on both sides of the TV. The positioning of
speakers is important, since this dictates the overall sound quality
of the multi channel system. Set up the speakers on the basis of
your listening position by following the owner's manual supplied
with your amplifier.
■Using as presence or surround speakers
Mount the speakers on a wall or place the speakers on a shelf.
Determine the best position by following the owner's manual
supplied with your amplifier.
NS-B700
Presence
NS-B700
Front
Notes
• Placing this unit too close to a TV set might impair picture
color or create a buzzing noise. Should this happen, move
the speaker away (more than 20 cm (7-7/8")) from the TV
set.
• To avoid accidents resulting from tripping over loose
speaker cables, fix them to the floor.
Subwoofer
Center
NS-B700
Surround
back
NS-B700
Surround
■To mount the speaker on a wall by using
the attached mounting bracket
Fasten screws into a firm wall or wall support as shown in the
figure, and hang the holes of the mounting bracket on the
protruding screws. By setting the two supplied bass control plugs
into the ports on the rear of the speaker, the tone and volume
balance of the low bass sound produced between the port and the
wall will be optimized.
* Make sure that the screws are securely in the narrow sections of
the holes.
Tapping screw (3.5-4 mm) (5/32"-3/16")
(Available at the hardware store)
Wall/wall
support
You can also use the screw holes on the rear of the speaker for
installing the speaker using a commercially available speaker
bracket (if you do not use the attached mounting bracket).
WARNING
• This speaker weighs 3.5 kg (7 lbs. 12 oz.). Do not mount it on
thin plywood or a wall with soft surface material. If
mounted, the screws may come out and the speaker may
fall. This may damage the speaker, or cause personal injury.
• Do not install the speaker on a wall with nails, adhesives, or
any other unstable hardware. Long term use and vibrations
may cause it to fall.
• To avoid accidents resulting from tripping over loose
speaker cable, fix them securely to the wall.
Min.
3 mm 20 mm
(1/8") (13/16")
40 mm
(1-5/8")
Screw holes
Diameter: 6 mm (1/4")
Hole Depth: 15 mm (19/32")
60 mm (2-3/8")
1
En