Dry Ironing - Fagor PL-2600 Manual De Instrucciones

off and do not try to repair it. Repairs
should only be carried out by a Technical
Assistance Service authorised by the
manufacturer. Always demand the use of
original spare parts. Any failure to follow
the above instructions could affect the
safe functioning of the appliance.
• If you decide never to use the appliance
again, cut the lead, first ensuring that the
appliance is unplugged.
• The user should never attempt to change
the cable. If, for any reason, the cable
requires changing, contact a Technical
Assistance Service authorised by the
manufacturer.
• Never hold the appliance under the tap
to fill the water deposit.
• Do not let the mains cable touch the hot
parts of the iron.
• During use, the appliance becomes
extremely hot and can cause serious
burns. Always pick up the iron by the
handle and avoid contact with the
metallic parts and steam.
• Do not turn the iron towards people
when it is expelling steam. This is
extremely dangerous.
• Do not use the iron on very wet fabrics.
• Do not store the iron in a horizontal
position (base down) whilst still hot. Wait
until it has cooled.
• Do not mix stain-removers or similar
products on fabrics to be ironed.
• Unplug the iron when not in use. Never
leave plugged in when not absolutely
necessary.
• The appliance contains a safety device
which, when activated, interrupts the
working of the iron. To reactivate your
iron, contact an authorised Technical
Assistance Service.
• If you decide never to use the appliance
again, remove the plug from the socket
and render it useless by cutting the
power cable.
• For greater protection, we recommend
installing a residual current device (RCD)
with an operational residual current not
exceeding 30 mA. Ask your installer for
advice.
4. BEFORE USING YOUR IRON FOR
THE FIRST TIME
Remove all stickers or protective labels
from the base and the body.
Unroll and straighten the electrical cable.
Follow the instructions given in the
"Self-cleaning" section in point "10 –
CLEANING", in order to prepare your iron
for use.
INSTRUCTIONS FOR USE

5. DRY IRONING

1. Place the iron on a stable and heat-
resistant surface.
2. Turn the temperature selector knob (2) to
MIN (Fig. B).
3. Slide the steam control knob (7) to the
dry iron position (Fig. C).
4. Place the iron in an upright position,
resting it on the support base (10).
5. Plug it in and turn the temperature
selector to the desired position. The pilot
light (4) will come on.
6. When the iron has reached the selected
temperature, the pilot light (4) will switch
off. This pilot light may turn on and off
several times while you are ironing,
indicating the cycles of the thermostat.
Remember that if you change from
a higher to a lower temperature, the
pilot light (4) will remain off until the
temperature of the base (1) has dropped
to the selected level, at which point it will
come on again.
7. When you have finished, turn the
temperature selector to MIN and unplug
the iron. Leave to cool before cleaning
the exterior and storing.
When you are dry ironing, you can
use the spray option at any moment,
providing there is water in the deposit.
(See sections entitled "Spray" and
"Filling the deposit").
14