Ashley M9X832 Manual De Instalación Y Operación página 11

Se ing Programmable Posit
and Pairing Remote
The original remote that comes in the box is already paired to the foundation. No further action is required.
In the event when the remote is not paired with the foundation, follow the following to pairing instructions.
M9X8 PAIRING REMOTE
STEP 1： Make sure the batteries are
good. Replace them when
needed.
STEP 2： Unplug the power cord
from the power source.
If 9V backup batteries
were installed in the
power supply, remove
them.
STEP 3：Press and hold
and simultaneously
until the blue backlights
of the remote control
are off.
STEP 4： Plug the DC power cord back into the power source.
You will hear an activation sound in 2 seconds,
indicating the remote is paired to the power
foundation.
SETTING PROGRAMMABLE POSITION
The M9X8 and M9X9 power bed has a programmable feature that
allows you to save two custom positions.
Please read all the instructions below before setting your custom
presets on the remote.
M9X8 REMOTE
STEP 1： Adjust the head and foot to your desired position.
Press and hold the LED on/off button
STEP 2：
then press and hold one of the picture programmable
buttons for 5 seconds until you hear a beep
1 2
sound. The position is then saved.
STEP 3： To adjust a saved position, repeat step 1 and 2
and the new position will be saved.
M9X9 REMOTE
Adjust the head and foot to your desired position.
STEP 1：
Press and hold the LED on/off button
STEP 2：
5 seconds until the LCD screen shows SAVE, and
press picture programmable buttons
hear 2 beep sounds.
To adjust a saved position, repeat step 1 and 2
STEP 3：
and the new position will be saved.
HEAD FOOT
Press And
Hold
1 2
STOP
first,
for about
until you
1 2
Customer Service Toll Free:
—08—
ions
M9X9 PAIRING REMOTE
Make sure the
STEP 1：
batteries are good.
Replace them when
needed.
STEP 2： Unplug the power cord from the power source. If
9V backup batteries were installed in the power
supply, remove them.
Press and hold Select button
STEP 3：
screen of the remote control shows PAIR.
STEP 4：Plug the power cord back into the power source.
You will hear an activation sound in 2 seconds,
indicating the remote is paired to the power
foundation.
SETTING REMOTE LOCK
The M9X9 power bed has a lock feature that allows you to lock the
remote. Read all the instructions below.
LOCK
Press and hold the HOME
simultaneously for about 5 seconds until the LCD screen
shows LOCK.
UNLOCK
Press and hold the HOME
about 5 seconds until the
screen.
LOW BATTERY
The LCD screen will show LOW once the batteries are in
low power.
1-800-248-5988
HOME SELECT
SNORE TV Z-G
1 2
STOP
until the LCD
and SELECT buttons
and SELECT buttons for
LOCK disappears on the LCD