Philips AVENT SCD525 Manual De Instrucciones página 21

Question
Why does the appliance
produce a high-pitched
noise?
Why don't I hear a
sound/Why can't I hear
my baby cry?
Why does the parent
unit react too quickly to
other sounds?
Why does the parent
unit react slowly to the
baby's crying?
Why do the non-
rechargeable batteries
of the baby unit run low
quickly?
Answer
If the parent unit beeps and the battery symbol on the display is
empty, the rechargeable battery pack of the parent unit is running low.
Recharge the parent unit.
If you have switched off the volume while the sound alert is on, the
parent unit beeps whenever the fourth sound level light lights up
because the baby unit has picked up a sound.
If you have set the room temperature range on the parent unit and
the temperature alert is on, the parent unit beeps when the
temperature drops below the set level or 57°F (14°C) or when the
temperature rises above the set level or above 86°F (30°C).
The baby unit may be switched off. Switch on the baby unit.
The units may be too close to each other. Make sure the parent unit
and the baby unit are at least 3.5 feet/1 meter away from each other.
The volume of the parent unit may be set too high. Decrease the
volume of the parent unit.
The volume of the parent unit may be set too low or may be switched
off. Increase the volume of the parent unit.
The microphone sensitivity level of the baby unit may be set too low.
Set the microphone sensitivity level to a higher level in the menu of
the parent unit.
The baby unit and the parent unit may be out of range of each other.
Reduce the distance between the units.
The baby unit also picks up other sounds than those of your
baby. Move the baby unit closer to the baby (but observe the minimum
distance of 3.5 feet/1 meter).
The microphone sensitivity level of the baby unit may be set too high.
Decrease the microphone sensitivity level in the menu of the parent
unit.
The microphone sensitivity level of the baby unit may be set too low.
Increase the microphone sensitivity level in the menu of the parent
unit.
The microphone sensitivity level of the baby unit may be set too high,
which causes the baby unit to transmit more often. Decrease the
microphone sensitivity level in the menu of the parent unit.
The volume on the baby unit may be set too high, which causes the
baby unit to consume a lot of energy. Decrease the volume of the baby
unit.
EngliSh
21