Safety Warnings; Environmental Information - Seamaid LEDINPOOL 501498 Manual De Instalación Y Mantenimiento

6. OPERATION
This LED projector is used as a traditional incandescent lamp.
The driving mode is given by the On/Off interrupter in the electric panel.
An optional ~12V radio remote controller of the same brand can be installed.

7. SAFETY WARNINGS

> Before any operation ensures that the main power supply is turned OFF
> All electrical connections must be made out of water
> Do not handle with wet feet
> Comply with the current standards regarding accident prevention
> In this regard, the IEC 364-7-702 standards must be observed : WIRING IN
BUILDINGS, SPECIAL WIRING, SWIMMING POOLS.
> The persons in charge of the assembly of this product must have the qualification
required for this kind of work.
> Stop by the remote corresponds to a standby mode. If stopping over 24 hours, it is
recommended to use the switch located upstream of the transformer
8. GUARANTEE
This LED projector is guaranteed 24 months against any material and/or manufacture defect
(electronic components) from the date of delivery. (Keep the purchase invoice/receipt)
The projector is not guaranteed against problems coming from external shock, electric short-circuit or
excessive screwing. The product is not guaranteed against electrical excessive voltage coming from
the external power supply. (In this case, refer to the house insurance coverage)
This guarantee is conditioned with the strict respect of these instructions of assembly and
maintenance. Under this guarantee, the only obligation falling on the manufacturer or distributor will be
the free replacement or repair of the product or the element found defective by their after sale
services. All the other expenses will be the responsibility of the purchaser. For any replacement or
repair, the product must be subjected to an inspection to the after-sales service of the manufacturer or
distributor.
The guarantee does not play in the event of apparent vice.
The defects and deteriorations caused by the fair wear and tear, the defects resulting from a wrong
assembly and/or employment, and the modifications of the product carried out without the written and
preliminary assent of the manufacturer are all also excluded.

9. ENVIRONMENTAL INFORMATION

In accordance with the European Directive 2002/96/CE, concerning the electric and
electronic component scrap (EEED), the consumer must turn over the used product to
the collect points envisaged to this end.