Friedrich QuietMaster SS08 Manual Del Usuario página 17

Figure F TYPICAL INSTALLATION
TRIM MOULDING
SCREW #1A x "
LONG (USE )
SILL PLATE GUIDE CHANNEL
INSIDE WALL SURFACE
STEP 6
Slide the cabinet into the hole far enough to allow the guide-
channel of the sill plate to contact the inside wall surface (See
Figure F).
STEP 7
Drill three (3) ⁄ " dia. pilot holes through holes in sill-plate
5
32
into framing and install three (3) #12A x 2" long screws (See
Figure F).
NOTE: ALTERNATE FASTENERS WHICH MAY BE USED FOR
SECURING THE SILL PLATE IN THE WALL AND THE SUPPORT
BRACKETS TO THE OUTSIDE WALL (NOT FURNISHED BUT
AVAILABLE AT LOCAL HARDWARE STORE).
EXPANSION ANCHOR BOLT
MOLLY OR TOGGLE BOLT
920-198-00
CAULK ALL SIDES WEATHER TIGHT
⅜" SLOPE DOWN
NOTE: SUPPORT BRACKETS MAY BE OMITTED
FROM THROUGH-THE-WALL INSTALLATIONS IF THE
CABINET IS SECURED AS FOLLOWS. DRILL  HOLES
IN EACH SIDE AND INSTALL 4 FASTENERS ( EACH
SIDE). USE #1 x " SCREWS, TOGGLE BOLTS OR
EXPANSION ANCHOR BOLTS AS SHOWN IN STEP .
CABINET
SUPPORT BRACKETS (AVAILABLE AS OPTIONAL ACCESSORY)
SCREW #1 x " LONG, USE ONE EACH BRACKET.
⁄
DRILL 5 DIA. PILOT HOLES.

STEP 8
Drill two (2)
shown (see Figure F) and install four (4) #12A x 2" screws (Item
# 4, page 9). Provided that Step 5 (hole construction) provides
a sturdy mount with solid vertical studs, no support brackets
are required. The installation must support the weight of the
unit plus an additional weight of 400 pounds on the rear of the
cabinet.
If support brackets are available, they can certainly be used for
through-the-wall installations as shown in Figure F.
If the reliability of the wall is in question, a window installation kit which
includes support brackets can be ordered (see Accessories).
STEP 9
If desired, trim around the cabinet on the room side with a suitable
frame moulding furnished by the installer (see Figure F).
STEP 10
Complete the installation by following steps 13 through 18 of SASH
WINDOW INSTALLATION INSTRUCTIONS, pages 13-14.
STEP 11
Refer to the OPERATION SECTION for instructions.
⁄ " dia. pilot holes each cabinet side at the locations
5
32
1