System Configuration - Astralpool 42350 Smart+ 60 Manual De Instalación Y Mantenimiento

5. OPERATION: _______________________________________________________________________________________________
5.1. System stopped
The system enters "stand-by" MODE when the "
production in the electrolysis cell.

5.2. System configuration

The AstralPool Chlore Smart+ system can be reconfigured through a menu accessed from the control panel. The system has to be switched
off, as described in point 5.1, in order to access this menu. Once the system has been switched off, press the "-" [1] key for a few seconds
until the system information screen [11] displays "CONF". To enable selection of each menu option, keep the "SALT TEST" [9] key pressed
for approximately 1 second. Select the desired parameter using the "-" [1] / "+" [14] keys and validate by pressing the "SALT TEST" [9] key for
one second again (see Fig. 19). The configuration process enables you to establish the following operative parameters:
MODEL
SOFTWARE VERSION
POLARITY SWITCH
OUTPUT LEVEL CONTROL WHEN CLOSED COVER
COVER CONTROL INPUT ACTIVATION
ORP/RESIDUAL CHLORINE CONTROL INPUT
ACTIVATION
GAS DETECTOR ACTIVACION
EXTERNAL FLOW DETECTOR
(FLOW SWITCH)
ACTIVATION
(1)
WARNING: only use this mode for check tasks, for short periods of time, as it could damage the electrodes.
(2)
Factory defaults.
-
" key [1] is pressed successively until the "0 %" led flashes. In this situation there is no
Fig. 19
Smart+ 60
Switch each 2 hours
System may be configured to provide an output to cell in the range 10 ... 90% of its nominal
(2)
Deactivated
(2)
Deactivated
Deactivated
Deactivated
Fig. 20
14
Smart+ 100
Shows software version (two digits)
(2)
Switch each 3 hours
(2)
capacity when the pool cover is closed.
Activated input when closed
contact
Activated electrolysis system when closed contact
Activated electrolysis system when submerged detector
Activated electrolysis system when closed contact
Smart+ 160
(1)
Switch each 2 minutes
Activated input when open
contact
(2)
(2)