Ribimex Ribiland PRBAT20/S Manual De Instrucciones Y Mantenimiento página 28

- Insert fully charged battery on tool.
- Then disconnect charger from mains and store it adequately.
Note: Maintain the charger and the battery at a temperature between +10°C and +40°C.
Tips to ensure optimal battery life:
- Do not to drop, hit, or damage the battery.
- Recharge the battery before it is completely drained.
When you notice that the tool performance is decreasing, recharge the battery accordingly.
- Never charge a fully charged battery. Overloading reduces its life.
- If the battery is hot, allow it to cool down before proceeding with charging.
- When the product is not used, it is recommended to charge the battery every 3 months.
4.4- Starting the machine (Fig.1)
- Switching on: push forward the switch (6) to position "I".
- Switching off: pull back the switch (6) to position "0".
V. OPERATION
5.1- Intended use
- The product is intended for outdoor domestic use in private gardens/property.
- The tool is only suitable for blowing dry leaves, grass ... within the limits of its characteristics.
- Do not use the machine for applications not described in this manual.
- Do not use the machine for unsuitable purposes (for ex. blowing fire, flammable or explosive
material, ...). Do NOT operate on damp or wet working area.
- The tool is not intended for artisanal, commercial, professional and/or industrial use (for ex.: in
public parks...).
5.2- Operation
Before any operation:
-- always visually inspect that the product does not show signs of use or damage
-- check that the screws, bolts and nuts are well tightened.
-- replace any used or damaged part, and tighten firmly the screws, bolts and nuts when needed.
Important - Before starting work:
- Repeat several times the starting and stoppage of the machine to become familiar with it.
- Make trial work on small area to become familiar with handling the machine.
1. Ensure that battery is charged, otherwise proceed with charging.
2. Wear appropriate protective equipment.
3. Clear working area off any objects likely to pose a hazard.
4. Inform persons to stay away from working area and machine while you are working.
5. Firmly hold tool with hand, and always maintain a balanced and secure position.
6. Place air outlet (1) above the working area. Do not make sudden movements.
7. Push switch (6) to "I" to start operation.
8. Start operating on working area with slow left-to-right movement, working through small areas at
a time. Do not make sudden movements.
9. Never work on wet or very damp grass / materials.
10. Once work is finished, stop product by pulling the switch (6) to "0" position.
ATTENTION! Do not assume of your knowledge of the tool.
DO not be filled (over repeated use) with a sense of ease and familiarity with the tool, neglecting
Page 28 / 78