Maintenance And Storage - Ribimex Ribiland PRBAT20/S Manual De Instrucciones Y Mantenimiento

strict compliance to the safety instructions given with the tool.
Improper use of the tool or failure to comply with the provided safety instructions in this manual can
cause severe injury.
Remember that a split second of negligence is enough to cause serious damage.
Remain alert about your surroundings and especially for any danger that you may not hear while
using the tool.
5.3- Tips for using the blower
The following points may assist you in the operation of the tool:
- Always try to blow dry leaves, cuttings or general garden debris.
Wet materials are difficult to work with and also can cause the blower to clog.
- Avoid using the blower on areas where there are stones, or other hard objects.
These objects may be projected and cause injury or damage to property.
VI. MAINTENANCE AND STORAGE
Before any intervention on product, switch off tool and remove the battery.
Reminder: Make sure to maintain the machine in good working condition, carry out regular
maintenance of the machine after each use and before storage.
Any breach or default of adequate maintenance reduces the life of the machine and increases the risk
of breakdowns and accidents.
To preserve the security system throughout the life of the machine, it is important to perform
maintenance and proper cleaning, DO NOT use non-compliant replacement parts and do NOT
dismantle yourself the machine or change the security features.
6.1- Maintenance
- Check your machine regularly before starting any work. Check the machine carefully and replace
worn or damaged parts for safety.
- Keep all nuts, bolts and screws tight to be sure that the machine is in safe working condition.
- Damaged tool must be repaired or exchanged by a qualified person before working with the machine.
- Do not attempt to repair the machine yourself, to avoid any danger.
- Only use original accessories and spare parts.
6.2- Cleaning
a) Clean the plastic parts with a soft and clean cloth and dry the housing carefully.
Do not use aggressive cleansing agents (solvents, abrasive cleansers) or an abrasive sponge or any
sharp objects.
- Do not use any caustic chemicals to clean the plastics parts.
- Never put or immerse the product in water or any liquid, and ensure that water does not penetrate the
tool. Never splash with water or clean with high pressure hose! Do not clean under running water.
b) Clean the tool after each operation.
c) Always keep the ventilation slots in motor housing clean. Clean ventilation holes with soft brush.
6.3- Storage
- Clean tool before storage.
- Keep product, user manual and accessories in the original packaging.
- It is recommended to store the product in a clean, dry location, protected from humidity, frost and
dust, and keep it out of children's reach (e.g. high or in a locked-up place).
- Do not store product in temperatures lower than 0ºC (32ºF)
- Do not place or store any object on top of the product.
Page 29 / 78