Using The Swash Se600 - brondell Swash SE600 Advanced Manual Del Usuario

OPERATING THE SWASH (cont.)

USING THE SWASH SE600

NOTES:
• The wash functions will not work unless the sensor in the seat detects someone sitting
down (with the built-in skin conductivity sensor). To override the Seat Sensor, please see
the instructions on Page 20.
Prepare for Wash
Sit on the seat to ensure skin-to-seat contact on the Seat Sensor. Once contact is made the seat
will automatically:
1. Give an audible beep letting you know the Seat Sensor has been engaged.
2. If the bidet was set to Eco Mode, the seat and water temperature will rise to the set
temperature settings.
Warm Water Wash
When ready to wash, press the Rear Wash or Front Wash button on the control panel one time to
initiate a wash. The nozzle will self-clean, extend into the toilet bowl, spray for two minutes, turn
off automatically, retract, and self-clean once again.
1. While washing, users can adjust the water temperature, pressure, and nozzle position settings,
as well as initiate the Massage and Pulse features by following the notes on Page 16.
2. If you would like to stop the wash before the two minute cycle ends, press the Stop button to
discontinue water flow.
3. After extended use the water may decrease in temperature if a LO, MEDIUM, or HI water
temperature setting is selected. To regain warmer water, stop all wash functions for three
minutes to allow the bidet to reheat the water.
Warm Air Dryer Function
Press the Dry button to activate the warm air dryer. The dryer will run for two minutes and turn off
automatically.
1. While the air dryer is operating, users can adjust the dryer temperature to a comfortable level
+"
using the Dry "
LED lights (see Page 15).
2. If you would like to stop the dryer before the two minutes has elapsed, press Stop.
Deodorizer
Press the Deodorizer button to activate the deodorizer for a one minute cycle. Push the Stop
button to turn the deodorizer off. Note that the deodorizer will not function during any wash or
dry cycle.
18
–"
and " buttons. The dry temperature will be reflected on the five indicator