Installation - Ashley Signature Design P015-900 Manual Del Usuario

1. Flip the body (D) horizontally down on a
protected surface. Remove the glass tube
(C). Attach the tank holder (H) to the base
of the body (D) using 4 M6*20 screws (AA),
4 6.2 flat washers (BB) . Flip the body(D)
over.
Note: Make sure the wing screw on the
tank holder (H) faces the door on the body
(D).
2. Slide the 3 upper supporters (F) into the
slots at the top of the burner (L). Once fully
inserted secure the upper supporters (F)
into the burner (L) by replacing the 3
M5*15(CC) screws and 3 6.2
washer(BB).Flip the body(D) over.
Note: Be sure that the hooks on the
upper supporters (F) are facing
upwards.
3. Attach the glass tube ring (J) to the
burner(L) using 3 M4*12 screws(EE) and
3 4.2 flat washer(FF).
P015-900

INSTALLATION

Page 10 of 49