Operation - John Bunn Neb-u-Lite LX2 Manual De Usuario

Note: The reservoir tube, shown in the illustration earlier in
this manual, acts as a holding tank for the mist, reducing the
amount lost during treatment. Its use is optional. If you wish
to use the reservoir tube, install it now on the small end of
the T adapter.
8. Install T adapter onto top of nebulizer
medication cup cap.
9. Connect the tubing to the adapter on the
bottom of the nebulizer medication cup.
10. Connect the tubing's other end to the
compressor air outlet connector.
WARNINg: Before use, check that all parts are securely
connected. Use of an improperly assembled nebulizer
could diminish or prevent adequate delivery of medication
and the effectiveness of the treatment.

oPeRAtIoN

Caution: The Neb-u-Lite LX2 Nebulizer Compressor is
s
designed for intermittent use only. Do not operate it
continuously for more than 30 minutes for a single use
without turning it off and allowing a cooling period of
least 30 minutes.
1. Ensure that the ON/OFF switch is in the OFF position.
2. Plug the power cord into a properly grounded electrical
wall outlet.
3. Move the ON/OFF switch to the ON position to start the
compressor.
4. Place the nebulizer mouthpiece between teeth and close
mouth (or install the optional mask on face).
5. As aerosol starts flowing, inhale deeply and slowly
through mouthpiece (or optional mask).
WARNINg: Never use a nebulizer with a clogged nozzle.
If the nozzle is clogged, the aerosol mist will be reduced,
altered or stopped, which will diminish or eliminate the ef-
fectiveness of the treatment. If clogging occurs, replace the
nebulizer.
John Bunn Neb-u-Lite LX2 Nebulizer Compressor
T adapter
cup
install
T adapter
on cap
8