Rs232 Serial Interface; Sending Data To The Pc (Auto Control) - Techne Tecal 650S Manual Del Operador

RS232 SERIAL INTERFACE

The calibrator may send data logging information to an IBM PC or compatible
computer by connecting the unit and the PC via an RS232 cable, and installing
the "Calsoft" software. Contact your supplier for details.
Ensure that there is a connection made before the calibrator is switched
on.
The RS232 cable must be fitted to both the unit and the PC before either unit is
powered up, otherwise, data integrity cannot be guaranteed. Once the cable is
fitted, it does not matter which unit is powered up first.
RS232 9-way PC serial port
ON/OFF switch
Fuses
The following tables indicate the cable specifications for a 9-way PC serial port:
Calibrator
9-way female D type
pin
Case
3
2
7
8
6
1
4
5
Sending data to the PC
The procedure for sending data to the PC is described in the instructions
supplied with the software. The PC must be properly connected by the RS232
cable and running Calsoft to accept or display data.
T E C A L 6 5 0 S O P E R A T O R ' S M A N U A L
PC
9-way female D type
signal pin
F.GND Case
TxD 3
RxD 2
RTS 7
CTS 8
DSR 6
CD 1
DTR 4
S.GND 5
Power inlet
PAGE 15